1. Design Requirements: Select appropriate size and system as determined by site conditions to prevent
    birds from landing and roosting on specified surfaces.

1. Single Source responsibility: Furnish products from one manufacturer for entire project.

2. Obtain all technical information from the manufacturer.

3. Utilize labor or Birdslide Authorized installers who are knowledgeable in Birdslide  product installations.

4. Installer shall visit the site to gather all information of existing site conditions.

1. Product Data: Submit manufacturer’s descriptive literature and product specifications for each product
    including catalogs, installation instructions other descriptive material.

2. Provide Warranty on Material and Installation.

3. Provide samples of Bird Slope excluding proposed fastening methods.

4. Provide statement by official indicating that they are a certified installation company.

Birdslide
Simi Valley, CA

Tel:866-48-BIRDS  or  866-482-4737
Fax: 805-

1. Model Designation:

   A. BIRDSLIDE

       1. Width of Coverage: 1" to 5 7/8 inches. Leg extension coverage up to 14".

       2. Length: 4 ft. (Girders / Rafters / Struts / segments); 5 ft., 6 ft., 8 ft., 10 ft., and custom order up
           to 20 ft. beams.

       3. Packaging: 80ft./Box…20-4ft. beams/box.

       4. Color: Grey or Beige– Can be painted to match desired color and structure. Extruded in any color on
           special order. Our technicians do the painting on location.

       5. Width of Coverage with Extension Leg: up to 14"

       6. Length of Extension Leg: 2 ft. segments.

       7. End Covers: Use to close off ends of installed BirdBlide structure for aesthetic as well as practical
           reasons (to stop access of pests into the structure).

       8. Assembling BirdSlide: Glued, screwed, riveted or clipped and based on local conditions.

1. Material: U.V. protected Outdoor Plastic / Sun & Weather Resistant with appropriate installation.

2. Construction: One-Piece design, flexible and easy to work with extruded material.

3. Alterations/Modifications: Cut to desired width with utility blade..

1. Recommended "Ultimate Bond" adhesives supplied by BirdSlide. com.

2. For under eave installations consult your BirdSlide dealer.

1. Examine the installation area and note any negative or hazardous work conditions. Notify contracting
    officer or inspector of the negative and unfavorable work conditions.

2. Do not proceed with installation and assembly until conditions are corrected.

1. Surfaces should be thoroughly examined, cleaned and free of bird droppings, nesting materials, rust,
    peeling paint or other debris.

2. Remove or repair articles that may damage BirdSlide after assembly and installation, including but not
    limited to overhanging foliage, brush and loose fragments or component parts of the structure.

1. Install BirdSlide by BirdSlide Certified Installer.

2. BirdSlide should be installed correctly, covering the entire depth of the surface.

   a. Follow the contours and angles closely.

   b. Space materials in accordance with BirdSlide’s recommendations.

   c. Use End Covers to close off ends as necessary.

1. Visually inspect BirdSlide for any signs of poor installation, including debris not removed.

2. Correct and repair as necessary.

END OF SPECIFICATIONS